Do you have recessed broken lighting at home that is getting dimmer? You might have any thoughts on how to fix it by yourself or are even scared of being electrocuted. Don’t worry, because by learning these five replacing recessed lighting guide tips, you can return it by yourself at home without begging to ask for help from a technician or neighbors.
Essential Steps to Substitute Recessed Lighting
1. Turn off the electricity circuit
To avoid accidents, it’s highly recommended and essential to turn off the electrical circuit. Even so, there is another way by simply turning off the switch. This method is not recommended due to remaining electricity, or in the worst case could cause a problem to another of your electronic devices. Don’t forget to keep everything dry and all safe from the water!
2. Get ready to replacing the lightbulbs
After you have done the first step, you can take a ladder to reach the ceiling. If you don’t have a ladder, you can use a table or chair to get on top of replacing recessed lighting with the help of the supervision of someone closest to you. Put your fingernails toward fighting on opposite sides. After that, turn the lighting clockwise and pull it down very carefully to avoid falling.
Not all recessed lights can be removed only by hand; sometimes, you might need tools, like a screwdriver. If so, push up your screwdriver-facing bolts on top and turn counterclockwise. After the bolts have already been removed, you need to pay attention to them, so they are not missed. Therefore, the lightbulb can be installed again.
3. Unplug the cord
In the third step, you are allowed to unplug the lamp from the socket. Hold the light with one hand, and with the other hand, pull the chord so the old house can be taken. Take care of wires with some awareness. Then, replacing recessed lighting can be difficult; one mistake will have an impact on your cable breaks. If so, you need to prepare some costs to fix it again from the beginning.
4. Plug in the new wiring
Next, after unplugging the old wiring, take a new LED lamp. Make sure that the wattage included is suitable for your house. After this step, plug the cord into the socket available with push it away until you feel that those wirings are connected. Now it’s time for you to check if the light gets turned on and ready to use.
5. Check the lighting
The final step, don’t put the lightbulb back first. Instead, check your lighting while you hold on to the lamp, so you don’t need to work hard twice. Also, don’t touch the metal or brass inside the cable to replacing recessed lighting. But hold the plastic from the cable, so you do not need to get into an accident. After checking everything works well, then you can put the lightbulb where it belongs.
As a result, with the essential tips and best tricks, you can start replacing the lighting on your own. However, if you are not sure about doing it, you can ask a technician or experienced person. Because in some cases, just like if the lightbulb is so high that you can’t reach it, then you need a skilled person to replace it.